Questions & Answers for: spool problems Computers & Internet

There are two spools for the ribbon and one spool for the ticket roll. The first spool on which the ribbon is first attached no longer rotates, while the secon spool still wants to rotate (thus ...

Spool is bouncing on spool pin I was sewing and everything was fine, but then all of a sudden the spool started bouncing and the thread was spinning around the spool pin. I then got a "birdsnest" of ...

...problems. Please help, thank you the timing has, gone there is a screw holding the spool carrage on to the shaft lossen this a little so that it still grips but will turn, the neddle should pass the ...

RIBBON DOES NOT ROLL FLAT ONTO SPOOL TPYEWRITER HAS JUST BEEN BOUGHT BUT HAS A PROBLEM AND NOW I UNDERSTAND WHY IT WAS FOR SALE. RIBBON DOES NOT ROLL FLAT ONTO RECEIVING SPOOL. IT IS AS IF THE SPOOL ...

...Problem I have a WORX 2 in 1 GrassTrimmer/Edger WG150. What are the notches in the top of the spool used for? Do I have to put the wire through them in order to have a proper continous feed? ...

...bobbin area and needle appears to be stuck and won't move. Almost like the thread wont come off the spool. Check to see if the thread coming off the spool is tangling on the spool pin or getting ...

problems before I switched the ribbon out) but the issue is the typewriter itself. The spool holders are acting a bit tricky; when I flip the switch to have the ribbon change direction in output, only

Hi I use all the nylon on the spool when cutting edges with in a 5 meter length ( 3 spools to do 15m approximately) Grass length 30 to 50mm Hello. W/D here. It sounds like the line is wound on the ...

...ago. Hope this helps. Please read all the way through this before beginning to actually rewind the spools. 1. Pull the spool off of the head. Clear the dust and debris out. 2. Note that it is ...

I recently acquired a vintage underwood 315 typewriter. I bought new ribbon, 2 spools black. However when I put the spools on I cannot get the screws to do up as nothing comes far enough up the spools