Questions & Answers for: Cisco stack Computers & Internet

...Configuration register is 0x10F !!! WARNING: The switch is not usable !!! Unfortunately the show stack isn't showing any results other than it is either a hardware or software fault. I am guessing ...

I have 2 Cisco 24 port catalyst 3750 switches that are stacked. How do I enable Dynamic Link aggregation on them? This is so that I can use bond method 4 in Cent OS and use Link Aggregation on my MACs

...details about this issue. Recently, I had a similar situation with a SW-C3750-48TS-S which was in stack. Just after we removed it from the stack, it starts the fan and the light of SYST is Green

Cisco SG300-52 SRW2048-K9-NA, can you plug in all 52 ports at the same time? Each combo mini-GBIC port has one 10/100/1000 Ethernet port and one mini-GBIC/SFP Gigabit Ethernet slot, with one port ...

...i face a problem with WAP4410 that the laptop gets IP but smart phone /tablet doesn't connect stack when getting an IP with static IP the devices connected So what i did ,I went to the market ...

...SFP-gigabit ports on Cisco Catalyst 3750? While I am not 100% sure if you can or not, Cisco makes a Stack cable for the 3750s that is specifically designed to do what you are requesting. I recommend ...

...to the config mode when configuring again it reboots and give this error message : 1 00:01:09.055: %STACKMGR-4-SWITCH_ADDED: Switch 1 has been ADDED to the stack *Mar 1 00:01:10.632: ...

...2960-X series switches recently. The switches require at least 24-port, and can support flexstack+ for stacking of up to 8 switches with 80 Gbps of stack throughput. On the Cisco's product ...

cisco catalyst 2960 series switches support stacking? Are cisco catalyst 2960 series switches support stacWhat specific models support stacking? If it support stacking,do I need to increase the ...