To program your remote --
1. sit in the drivers seat and close ALL doors and insert the key in the ignition ( do not turn ).
2. press and hold the UNLOCK button on the door panel ( you will need to keep it pushed down during the next steps ).
3. turn the ignition switch ( do not crank the starter ) to ON and then OFF and the ON and then OFF again.
4. now release the UNLOCK button on the door panel.
5. now press and hold the lock and unlock button at the same time on the remote and hold them until the door locks on the vehicle cycle -- this will take about 30 seconds.
if you need to program more remotes -- just follow the same instructions with that remote.
all should be good.
c...
104 views
Usually answered in minutes!
×